Scale Autodesk Community Gallery Your drawing units will determine how you treat the length, input and measure of your lines. a line with length of 10 drawing units could be either 10 meters or 10 mm, it all depends on your drawing units. These settings do not change the actual scale of the drawing geometry. you should always draw 1:1 in model space, doesn't matter if you use meters or millimeters. the drawing scale setting only controls at what size annotative objects are placed in your drawing.

The Scales In Autocad Pdf Auto Cad Autodesk Zooming in gives a tighter scale (closer and closer to 1:1), while zooming out gives a looser scale. sometimes i will do something like that in order to see the entire object first, and then select known scales from a list to see if they go too far either way, or are just right. With the command "units" you can check the units of your file, if it is in meters and your drawing says something else, you must click the drawing to correct it. The command you want is ' dwgunits' (that's with a hyphen) and then follow the prompts, the first one is the units so you need to enter 4 for cm. Causes: the default scale list has scales defined for mm as the drawing unit. autocad doesn't recognize the mismatch until you close and reopen the drawing, when the scales definitions get adjusted to reflect the meter as the drawing unit.

Solved Scales And Units Autodesk Community The command you want is ' dwgunits' (that's with a hyphen) and then follow the prompts, the first one is the units so you need to enter 4 for cm. Causes: the default scale list has scales defined for mm as the drawing unit. autocad doesn't recognize the mismatch until you close and reopen the drawing, when the scales definitions get adjusted to reflect the meter as the drawing unit. Solution: to convert the units of a drawing that contains dynamic blocks, use the scale command before using the dwgunits command. follow these steps: at the command line, enter scale. at the select objects prompt, enter all. enter 0,0,0 for the base point. When inserting an object into an autocad drawing, the object is inserted at the wrong scale, or displays at the wrong scale when measured. this may occur with any object, including: the drawing might be set up in different units than expected. the geometry was originally drawn at the wrong scale. When setting the viewport scale in paper space, the drawing seems to be scaled at the wrong scale, either too big or too small in autocad. the units are set to a different value compared to the values set in dwgunits. In the drawing setup dialog box, click the units tab and set the drawing units, precision, angle, and other settings, as desired. to customize the scale list, click the scale tab and click edit scale list.