Solved Vlans And Inter Vlan Routingfigure 7 2 ï Practice Chegg Task 2#: configure vlan and inter vlan routing. rotero switch pco pci pc2 instructions: 1. create 3 vlans for students, staff and faculty. 2. assign each pc to a vlan 3. configure sub interface on the router for each vlan 4. configure the default gateway for each vlan. 5. copy and paste the configuration of the on the router. 6. show a snapshot. In this lab, you will create vlans on both switches in the topology, assign vlans to switch access ports, verify that vlans are working as expected, create vlan trunks between the two switches and between s1 and r1, and configure inter vlan routing on r1 to allow hosts in different vlans to communicate, regardless of which subnet the host resides.

Solved Lab 10 Configuring Inter Vlan Routing Task Chegg Inter vlan routing is a network configuration technique that allows communication between devices on different vlans (virtual local area networks) within the same network. vlans are commonly used to segment a network, improving performance and security by isolating traffic within each vlan. Question: configure inter vlan routing 2.1. configure inter vlan routing in this task, you will configure inter vlan routing on the switches. part 3: configure stp 3.1. configure stp in this task, you will configure stp on the switches. part 4: configure etherchannel 4.1. configure etherchannel in this task, you will configure etherchannel on the switches. part 5:. In this lab, you will configure trunk based inter vlan routing and verify connectivity to hosts on different vlans as well as with a loopback on the router. note: make sure that the routers and switches have been erased and have no startup configurations. In this lab, you will create vlans on both switches in the topology, assign vlans to switch access ports, verify that vlans are working as expected, create vlan trunks between the two switches and between s1 and r1, and configure inter vlan routing on r1 to allow hosts in different vlans to communicate, regardless of which subnet the host resides.

Solved Lab 10 Configuring Inter Vlan Routing Task Chegg In this lab, you will configure trunk based inter vlan routing and verify connectivity to hosts on different vlans as well as with a loopback on the router. note: make sure that the routers and switches have been erased and have no startup configurations. In this lab, you will create vlans on both switches in the topology, assign vlans to switch access ports, verify that vlans are working as expected, create vlan trunks between the two switches and between s1 and r1, and configure inter vlan routing on r1 to allow hosts in different vlans to communicate, regardless of which subnet the host resides. In this exercise, you will practice configuring both traditional and router on a stick inter vlan rout ing. the routers and switches have a basic configuration. the passwords are cisco for user exec mode and class for privileged exec mode. use your answers from the “inter vlan routing configuration exercise” to complete the tasks. step 1. Page > of 7 2 part 5: configure vlan and inter vlan routing step 1: configure vlans on sw1 a. configure vlans: vlan 10, 20 and 99, with names, students, staff and management respectively b. configure trunk link to allow eligible vlans and with native vlan 99. c. assign access ports to vlan 10 and 20, design your own vlan and interfaces mapping. This chapter describes how to configure switches and routers for inter virtual lan (vlan) routing. the configuration procedures and examples in this chapter are designed as a starting point to help you configure intervlan routing for your network environment. Switch port gi1 1 is used to connect to the router. which command should be entered to prepare this port for the task? 2. refer to the exhibit. the configuration shows commands entered by a network administrator for inter vlan routing. however, host h1 cannot communicate with h2. which part of the inter vlan configuration causes the problem?.